Whirlpool CA15WYR0 Use And Care Manual page 7

2. Insert carriage bolt up through slot on tray-frame side and
support leg.
3. Place one end of tray center over carriage bolt.
4. Then place flat washer, lock washer and hex nut.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
A. Hex nut
B. Lock washer
C. Flat washer
5. Insert second carriage bolt through tray side and attach other
end of support leg.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
A. Hex nut
B. Lock washer
6. Install support leg on other side.
A
B
C
D
E
D. Tray center
E. Carriage bolt
A
B
C
D
C. Flat washer
D. Carriage bolt
Install SMART-MOUNT
1. From inside, place SMART-MOUNT
down, in the window. Match the holes in tray side with the
predrilled holes in windowsill.
2. Using 2 - #10 - 12 x 1 " slot-head wood screws, secure the
tray frame to the window.
A
A. #10 - 12 x 1 " slot-head wood screws
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
3. With tray center pushed away from the windowsill, place a
level on the angled edge on top of the tray side. Be sure level
is against notch on tray side.
A
A. Angled edge on top of the tray side
B. Notch
4. Adjust SMART-MOUNT ®
angled edge on top of the tray side is level.
IMPORTANT: The tray must slope downward slightly toward
the outside to provide proper drainage for the air conditioner.
A
A. Bubble indicates the angled edge on top of the tray side is level.
B. Place level on angled edge against notch on tray side.
5. Tighten the hex nut just enough to hold tray center in place.
6. Repeat with other side.
7. Tighten hex nuts securely with
® Tray Assembly in Window
® tray, support legs facing
B
tray until bubble indicates the
B
" wrench.
7