Mitsubishi Electric SWL31-ETMC User Manual page 24

● About Parameter Change
If the [SET] key is pressed for two sec. or the forth digit of 4-digit parameter is determined with the
[SET] key while the parameter value of the parameter number to be changed is displayed, the
parameter value display will be changed from lighting to blinking and the mode will be switched to
the Parameter Setting Mode.
* Pressing the [MODE/BACK] key for two sec. enables the changed parameter. If other parameters
are to be changed successively, switch the parameter number, change the parameter value, and
finally press the [MODE/BACK] key for two seconds.
Do not turn off the power of the radio unit in the Parameter Setting Mode.
Otherwise, all the changed parameters will be invalid and the setting will
change back to the parameter values before changing.
● Parameter Value Change (1) (Single Parameter)
Single parameters (without sub-parameters) can be changed with the operation below.
* Master station
operation example
▲
▼
▲
▼
SET
▲
▼
BACK
MODE
▲
▼
SET
BACK
MODE
Pressing the [MODE/BACK] key for two sec. determines the parameter value and the Normal Mode is restored. (*1, *3, *4)
! ! ! Caution ! ! !
*1: The seven segment display blinks and the Parameter Setting
Mode is activated.
*2: Press for a short time in the Parameter Setting Mode (seven
segment blinking).
SET
*1
Change the value.
SET
Press for Blink Blink Blink Blink
two sec.
*2
Blink
Cancel
BACK BACK
MODE MODE
*3
▲
▼
SET
*4
Press for
two sec.
SET SET SET
Change the value of the blinking digit with
.
Blink Blink
BACK
BACK
MODE
MODE
*3: The seven segment display blinks and the Parameter
Setting Mode is activated.
*4: The parameter value can be changed with the
↑↓ buttons in the Parameter Setting Mode (seven
segment blinking).
24/43