How To Use - Valley Electronics Daysy Instructions For Use Manual

How to Use.

1. Every morning - before you get out of bed - pick up Daysy and briefly
press the activation button. The activation ring will light up quickly, and
your predicted fertility status will be displayed.
2. Press the button once more, and the lights of the activation ring will start
rotating clockwise. The measurement can begin.
3. Place the sensor tip under your tongue, as far back as possible to the left
or right, and close your mouth.
4. 2 beeps will mark the end of your measurement.*
5. After measuring, the fertility status displayed is valid for a maximum of 24
hours or until the next measurement in the morning. 18 hours after the last
measurement, Daysy will switch to the prognosis. You can review your
fertility status later in the day by pressing the activation button once.
8
*If you hear a grumble buzz the measurement was
not successful and you must take your temperature again.
Inputting menstruation.
When the violet light «menstruation» is blinking, Daysy is asking for your
menstruation.
– If you are menstruating, press and hold the activation button until the
violet light remains illuminated and you hear a beep. Confirm menstruation
for each day that you have it for at least 3 consecutive days.
– If you are not menstruating, don't do anything, the light will remain blinking.
– If you are menstruating and Daysy does not ask you, input menstruation
by pressing and holding down the activation button until the violet light
is illuminated.
Important: The first bleeding after stopping hormonal contraceptives is not a menstruation,
but a hormone-conditioned withdrawal bleeding. Do not enter menstruation for this bleeding.
9