Eureka Swan MULTI-FORCE Manual page 7

Periodically remove and clean the filter assembly. PLEASE NOTE: it must be
COMPLETELY dry before refitting.
Water inside the vacuum could cause malfunction.
Filter disassembly and cleaning: Raise the filter and remove the filter cover,
put the filter and its bottom cover under the tap for washing.
1. The filter parts can be put back for use only after being cleaned and dried thoroughly.
2. All parts must be properly installed, otherwise it will cause product failure.
3. Water is not allowed to penetrate into the vacuum cleaner electrical components, or otherwise
may cause product failure.
SC15814_16_IM.indd 7
GET TO KNOW YOUR VACUUM
Take out the filter
Illustration of the main unit
2
Main Brush. Step down the pedal of main brush to extend or Push
retract the bristles. As a general rule: extended for hard floor,
retract for carpeted floors.
Pet Turbo Tool (SC15816N only) Connect to end of the hose
in place of the Main Brush to make short work of pet hairs etc.
7
1
3
Push
Pull out the power cord to connect the power
supply:When you see the red mark on the power
cord, do not pull the power cord outward.
2
Press the ON/OFF button:Control the start
and stop of the vacuum cleaner.
3
Press the take up button: The power cord
1
is automatically rolled back into the machine.
Pull
Remove the
1
dust tank
Push
Separate
Dust tank maintenance
Open the dust tank: Gently lift the
dust tank open button, and then lift
up to open the dust tank cover.
Separate
Filter disassembly and cleaning: R
put the filter and its bottom cover
Take out the fi
1. The filter parts can be put back for use only
2. All parts must be properly installed, otherwi
3. Water is not allowed to penetrate into the v
may cause product failure.
19/10/2018 09:56