Fluke IRCON ScanIR3 Operating Instructions Manual page 9

To prevent possible electrical shock, fire, or personal injury follow these guidelines:
Read all safety information before you use the product.
•
Use the product only as specified, or the protection supplied by the product can be
•
compromised.
Read all instructions.
•
Do not use and disable the product if it is damaged.
•
Do not use the product if it operates incorrectly.
•
Make sure the ground conductor in the mains power cord is connected to a protective earth
•
ground. Disruption of the protective earth could put voltage on the chassis that could cause
death.
Replace the mains power cord if the insulation is damaged or if the insulation shows signs of
•
wear.
• Use in 110/230 VAC electrical systems can result in electrical hazards and personal injury, if
not properly protected. All instrument parts supplied by electricity must be covered to
prevent physical contact and other hazards at all times.
• The system integrator is responsible for the final safety of the system.
ScanIR3
Rev. A1 Mar 2015
Safety Instructions
9