ABRACADABRA PLATE
The Abracadabra plate system allows the baseplate configuration to be mounted to the board and
taken off and on with one simple hand screw.
ASSEMBLY:
A) Screw the Abracadabra horseshoe and baseplate to the board in the desired position using the (4)
M6 30 mm stainless steel Torx screws and the (4) T-nuts.
B) Slide the Abracadabra mastmount into the horeshoe and tighten the set screw firmly by hand.
ATTENTION: The set screw can also be tightened with the Torx T30 screw driver. For longer masts
(75 cm and longer), always use the Torx T30 screw driver to tighten the set screw.
B
SET SCREW
HORSESHOE
8
ABRACADABRA PLATE
MAST
MASTMOUNT
BASEPLATE
A
M6 30 mm Stainles Steel
Torx Screw + T-nut
ABRACADABRA POSITIONING TIPS
Moving the Abracadabra system towards the nose of the board will increase lift in relation to the
stance position on the board
Moving the Abracadabra system towards the tail of the board will decrease lift in relation to the
stance position on the board
HEAD-ON VIEW OF UNDERSIDE OF BOARD WITH ABRACADABRA BOARDMOUNT,
SHOWING NO MAST ATTACHED.
TRACKS
ABRACADABRA POSITIONING TIPS
naishfoils.com
9