Advertisement
ASSEMBLY INSTRUCTIONS
The Naish Foil System utilizes M6 bolts throughout. Remember that foils are utilized in a very corrosive
marine environment; here are four important tips to maximize the life of your foil:
1) Whenever possible, apply anti-seizing compound to the screw threads before assembling.
2) Always use the Torx head screw driver to avoid damaging the screw slots.
3) Disassemble and rinse with fresh water after each use.
4) Greasy fingerprints, especially coated in sunscreen, can affect the performance of your
foil mast. Clean it with pumice hand cleaner or a similar product for best performance.
It is easiest if you assemble your new foil for the first time in the order below:
A) ATTACH THE STABILIZER (REAR WING): With the fuselage right side up, foil mast slot upwards,
position the stabilizer on the flat top surface of the fuselage with the wingtips upwards (you can also
use the countersink on the screw holes to determine the correct orientation). Tighten until nice and
snug using the Torx T30 screw driver.
B) ATTACH THE FRONT WING: Turn the fuselage so it is bottom up, position the front wing (with logo
down) to the scarf joint. Thread the M6 20 mm titanium center screw until hand-tight. Do the same
with the other two screws.
C) ATTACH THE PLATE TO THE MAST: Using the (3) M6 30 mm titanium Torx screws, tighten beginning
with the center screw first, then the front and finally the back screw.
D) ATTACH THE MAST/PLATE ASSEMBLY TO THE FUSELAGE: Insert the mast into the fuselage, then
thread (3) M6 30 mm stainless steel Torx screws until hand-tight. As before, the final tightening order
is center screw first, followed by front screw and then back screw.
FIND MORE INFORMATION AND ALL AVAILABLE PARTS ON NAISHFOILS.COM.
6
ASSEMBLY INSTRUCTIONS
ASSEMBLY DIAGRAM
C
ABRACADABRA
PLATE
Naish Plate Options
Abracadabra Plate
MAST
Standard Plate
Tuttle Mount
Deep Tuttle Mount
Scarf Joint
FRONT WING
B
(3) M6 20 mm Titanium
Torx Front Wing Screws
ASSEMBLY DIAGRAM
(3) M6 30 mm Titanium
Torx Mast Screws
Attaching Abracadabra or
Standard Plate to the Board
M6 T-nuts
Torx Screws
Abracadabra Plate:
(4) M6 30 mm Stainless Steel Torx Screws,
(4) M6 Stainless Steel T-nuts
Standard Plate:
(4) M6 25 mm Stainless Steel Torx Screws,
(4) M6 Stainless Steel T-nuts
A
(2) M6 20 mm Titanium
Torx Stabilizer Screws
STABILIZER
(REAR WING)
FUSELAGE
D
(3) M6 30 mm
Stainless Steel
Torx Mast Screws
Shown: Naish Foil Complete–Abracadabra
naishfoils.com
7
Advertisement
