Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for OPTITEC Wireless Remote Control Wheel V3
- Page 1 Optitec Wireless Remote Control Wheel Operator Manual...
- Page 2 Wireless Remote Control Wheel 1. Raise-lower handle 2. Main support shaft 3. Shaft to Clamp Locating Lug 4. Outer Shaft Locating Strip 5. Shaft rotation Locking Keyway Slot 6. Inner shaft rotation Locking Key 7. Anderson plug 8. Motor gearbox drive 9.
- Page 3 Wireless Remote Control Unit 1. Aerial 2. Power “On” button 3. Button Press LED 4. Forward button 5. Reverse button 6. Left Turn button 7. Right Turn button 8. Battery (9 volt) compartment 9. Power “Off” button...
-
Page 4: Table Of Contents
Optitec Wireless Remote Control Wheel utilises a powerful motor to drive the Wheel in all directions on a hard, level, even surface at an approximate speed of 8 metres per minute with safe manoeuvring of caravans or trailers up to 3,500kg. - Page 5 Optitec Wireless Remote Control Wheel supports a loaded weight of 350kg. It is extremely portable with total weight of 22kg. The size of the ‘Wheel’ is 326x220x760mm and utilizing the Trolley Carry Bag (sold separately) can be easily packed in a car to travel.
-
Page 6: Safety
The 12V battery MUST be charged and in good condition to ensure Optitec Wireless Remote Control Wheel will operate to its full performance specification. If the caravan or trailer does not have its own hand-brake, the use of Optitec Wireless Remote Control Wheel is not recommended. -
Page 7: Installations
Installation Optitec Wireless Remote Control Wheel is designed to mount as a traditional jockey wheel. See the following procedures and refer to the photos and descriptions on Page 1. Attach Optitec Wireless Remote Control Wheel to the caravan or trailer clamp/s at... -
Page 8: Operations
Optitec Wireless Remote Control Wheel although it may do so very well, is not specifically designed to move a caravan or trailer on sand, gravel, soft soil &... -
Page 9: Quality Control
Quality Control The main body of Optitec Wireless Remote Control Wheel is manufactured from high quality steel. The wheel is aluminium alloy and the solid tyre is made of durable rubber. The wireless frequency of the remote control unit is within the approved spectrum range covered by Australian Standards. -
Page 10: Specifications
Optitec Pty Limited warrants this product against defects in material or workmanship as follows: Optitec Pty Limited will replace at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. - Page 11 Optitec Pty Ltd www.optitec.com.au Email: info@optitec.com.au...
Need help?
Do you have a question about the Wireless Remote Control Wheel V3 and is the answer not in the manual?
Questions and answers