Basic Operations; Charging The Slice; Prepping The Cutting Mat - Making Memories Slice Manual

ENGLISH

BASIC OPERATIONS

STEP 1

Charging the Slice™

To charge the Slice™ Cordless Design Cutter™:
1. Plug the power adapter into the Slice™, as shown below.
2. Plug the power cord into a grounded electrical outlet.
3. Leave the Slice™ plugged in for approximately 1 hour to fully charge it.
Note: You can also use the Slice™ while it is plugged in, if desired.
STEP 2

Prepping the cutting mat

To prep the cutting mat:
1. Apply a line of repositionable adhesive on one end of the glass mat.
2. Spread thin coat evenly across the glass mat with a foam brush, until it coats
the mat completely, as shown below.
3. Allow the adhesive to dry for at least 2 minutes.
Note: The adhesive remains white while it is wet and becomes clear once it is dry.
Note: Make sure the adhesive has dried properly before placing the paper on the cutting mat.
Tip: Before applying a new coat of repositionable adhesive, ensure the mat is clean and old
adhesive has been removed (see Basic Care p.18).
3
Step 1 Step 2
10