Remove acorn nut, loosen lock nut and turn adjustment screw counter-clockwise to increase
speed of the pushgate.
BLADES
Inspect cutting edges daily. Replace cutting edges when center blade has been worn to
approximately 4" and side edges worn to approximately 3".
CENTER BLADE
RIGHT SIDE BLADE
CAUTION
Failure to replace worn cutting edges may result in unnecessary wear to the earthmover sides and
floor.
Note: Please specify left or right cutting edges when ordering replacements. Left or right side parts
are determined by viewing from rear of the scraper.
When the scraper is placed into operation, the operator will have to "feel out" the amount of
depth of cut to obtain maximum loading efficiency. This is usually accomplished by taking a lesser
and more uniform cut; however, some soil conditions such as loose sand may require a "pumping
action" obtained by taking successive deep cuts and lifting out of cut as the tractor begins to lose
power or traction.
13