DRAWBAR HOOK-UP
FIXING BOLT
Keep the pull block on horizontal position tightening the fixing bolt. Be sure to loosen the bolt
before operating.
There are twenty-two different grease zerks on the machine; one on each cylinder pin; one on
each of the rear frame pivot pins; eight on the push gate; one on the ball and receiver; and one on
the swivel hitch.
The machine should be greased every four hours or daily, depending on usage.
The wheel bearings should be repacked yearly.
Check air pressure in all tires and kept at minimum of 50 lbs.
Lug bolts should be checked periodically. Refer to "Torque Values Chart" to determine correct
torque values when tightening hardware.
11