Table of Contents
Advertisement
CONTROL PANEL LED DISPLAY AND FUNCTION KEYS
Depress all Keys with fingers only! Do not use tools or other objects or permanent keypad damage will occur.
1. Amount of Inside Imbalance in oz. or g.
2. Amount of Outside Imbalance in oz. or g.
3. Position of Inside Imbalance.
4. Position of Outside Imbalance.
5. "ALU" Correction Mode Selection Indicator
(Use Key #10, "ALU" to select.)
6. Manual DISTANCE Setting Keys (a+ or a-) to manually
enter distance of rim outer edge to machine.
7. Manual WIDTH Setting Keys (b+ or b-) to manually
enter width of rim at bead.
8. Manual DIAMETER Setting Keys (d+ or d-) to manually
enter diameter of rim at bead.
9. Selection Key for Optimization of Imbalance.
10. Selection Key to choose "ALU" Mode
(See #5 for indication).
11. Selection Key to choose from "STATIC" or
"DYNAMIC" functions.
12. Selection Key to display imbalance amount
(Display #'s 1 & 2).
13. Selection Key to recalculate amount of imbalance.
14. EMERGENCY "STOP" Key.
15. "START" Key (Begins Spin Cycle, Guard must be
in down position).
FUNCTION KEY COMBINATIONS
Depress the listed Keys in the described combinations concurrently to achieve the desired functions:
NOTE: The following combinations are listed in this location for quick reference only. They are described in much greater detail further along in these instructions.
+
F
STOP
+
+
F
a –
+
STOP
+
C
F
+
FINE
F
8
= Guard Switch function setting
a +
= Toggle between ounce or gram settings
C
= Begin sequence for changing Balancer Settings
= Balancer calibration
= Balancer function checks
FIG. 6
1
3
6
7
8
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
2
5
4
9
12
10
11
13
Static
}
Alu
14
15
Advertisement
Table of Contents
