Table of Contents
Advertisement
MAINTENANCE
Unplug Balancer from power source before
beginning any maintenance.
• Keep external threads of the Main Drive Spindle clean
and lightly lubricated at all times.
• Turn Power Switch to the "OFF" position and unplug
Balancer when not in use.
• If Balancer is to be unused for an extended period, cover
with a moisture resistant dust cover before storing.
• Periodically check tightness of Main Drive Spindle bolt
with the included 8mm Hex Key [K].
• Every 8 hours of operation, drive belt tension should be
checked. To do so:
– Using the included 5mm Hex Key [K], loosen and
remove the retractable, built-in Wheel Measurement
Scale by pulling it from its shaft at the right front of the
cabinet (FIG 29).
– Using an 8mm wrench (not included), Remove 4
retaining screws and the formed plastic Top Cover
(FIG 30).
– Check tension by depressing the belt at mid-point
between both pulleys. It should deflect by 1/8" [4mm].
– To tighten, loosen 4 motor mounting bolts using the
included 10mm Flat Wrench [K], push motor rearward
while tightening mounting bolts.
– Re-check tension and re-adjust if necessary (FIG 31).
– Replace cover and Wheel Measurement Scale.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 29
FIG. 30
""""
FIG. 31
8mm Motor
Bolts
Slots
Deflect Belt 1/8"
19
Advertisement
Table of Contents
