Specifications - Hitachi FDS 9DVA Handling Instructions Manual

English
SPECIFICATIONS
POWER TOOL
Model
I
FDS9DVA
I
FDSI 2DVA
No-load speed (Low/High)
Wood
0-280 I O-84O/min. 0 - 350 / 0 - 105O/min.
Drilling
(Thickness 18mm)
18 mm 21 mm
Metal
Steel: 10 mm, Steel: 12 mm,
Capacity
-
(Thickness 1.6mm)
Aluminum: 12 mm
Aluminum: 15 mm
Machine screw
6 mm 6 mm
Driving
Wood screw
5.5 mm (diameter) x 45 mm (length) 5.5 mm (diameter) x 63 mm (length)
(Requires a pilot hole)
(Requires a pilot hole)
Rechargeable battery
I
FEB9S: Ni-Cd 9.6 V
I
FEBl2S: Ni-Cd 12 V
Weight
I
1.5 kg
I
1.6 kg
CHARGER
Model
I
UC9SD
I
UC1 2SD
Charging time
I
Approx. 1 hour (at 2O*C)
Charging voltage
I
9.6 V
I
12 v
Gewicht
I
1.2 kg
I
1.4 kg
STANDARD ACCESSORIES
APPLICATIONS
1 @ Plus driver bit (No. 2
x
55L) . . . . . . . . 1
FDS9DVA
1 @
Charger
(UC9SD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
IO
3
Plastic case . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
FDSl2DVA 1 ...........................
.......................................
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (FEB9S) (For FDS9DVA)
2. Battery (FEBl2S) (For FDSl2DVA)
Optional accessories are subject to change without notice.
0
Driving and removing of machine screws, wood
screws, tapping screws, etc.
0 Drilling of various metals.
0 Drilling of various woods.
BAlTERY REMOVAL/INSTALLATION
I. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see
Figs.
1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
fol:ows.
Insert the battery in the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in
the battery until it comes into contact with the
bottom surface. (See Figs. 1 and 3)
Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
About 1 hour is required to fully charge the battery
at a temperature of about 2O*C. The pilot lamp goes
off to indicate that the battery is fully charged.