Table of Contents
Advertisement
User Guide
If you clicked on save, the following pop-up screen will be displayed. Click on OK. This will save you Private
LAN Configuration settings. If you click Cancel, your new settings will not take affect.
NOTE: DHCP Lease Time is displayed in the following format: (dd:hh:mm:ss)* This value must be greater than 10
seconds. The default = 01:00:00:00. Seconds must be between 0 and 59, minutes must be between 0 and 59, and
hours must be between 0 and 23.
*(dd = days, hh = hours, mm = minutes, ss = seconds).
If the settings you have entered in the Private LAN Configuration screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check the settings in the Private LAN Configuration
screen.
Warning Message
Start Address is not part of the Subnet
End Address is not part of the Subnet
End Address is below the Start Address
Lease time must be greater than 10 seconds
Seconds must be between 0 and 53
Minutes must be between 0 and 59
Hours must be between 0 and 23
Public LAN Configuration
The following screen will be displayed if you select Public LAN from the Configuration menu. The Public LAN
feature, if available from your service provider, allows the Router to use LAN IP addresses that are accessible from
the WAN. Public LAN allows your computer to have global addressability.
NOTE: Both Private LAN and Public LAN cannot be disabled.
030-300331 Rev. A
Check Private LAN DHCP Settings
Check the value in the DHCP Start Address field
Check the value in the DHCP End Address field
Check the value in the DHCP End Address field
Check the values in the DHCP Lease Time fields
Check the Seconds value in the DHCP Lease Time field
Check the Minutes value in the DHCP Lease Time field
Check the Hours value in the DHCP Lease Time field
53
4-Port Router (Model 2400)
October 2002
Advertisement
Table of Contents
