EuroSteam Evolution 6399 Manual

EuroSteam Evolution 6399 Manual

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Evolution 6399 and is the answer not in the manual?

Questions and answers

Harriet meacher
January 31, 2025

Why won’t my euro steam iron evolution 6399 turn on?

2 comments:
Harriet meacher
January 31, 2025

@Harriet meacher

User image 679ccedb6d199
Mr. Anderson
May 14, 2025

The EuroSteam Evolution 6399 iron may not turn on for the following reasons:

- The iron is not plugged in. Plug the iron into a power outlet.
- The thermostat knob is not turned to the max temperature. Rotate the knob to the max position.
- The lamp has not yet switched on and off three times. Wait for the lamp to switch on and off at least three times.
- The lamp is not turning on at all. Contact an Authorized Service Centre.
- The iron may not be warming up. Contact an Authorized Service Centre.

This answer is automatically generated

Harriet meacher
January 31, 2025

My euro steam iron will not turn on. Model 6399

1 comments:
Mr. Anderson
May 14, 2025

The EuroSteam Evolution 6399 iron may not turn on for the following reasons:

- The iron is not plugged in. Plug the iron in.
- The temperature knob is not set to the max position. Rotate the knob to the max position.
- The lamp has not switched on and off at least three times. Wait for the lamp to switch on and off three times.
- If the lamp is off or the iron is not warming up after these steps, contact an Authorized Service Centre.

This answer is automatically generated

Summary of Contents for EuroSteam Evolution 6399

  • Page 2 Fig. B Fig. A Fig. D Fig. C Fig.F Fig. E...
  • Page 3: Important Warnings

    IMPORTANT WARNINGS CAREFULLY READ THESE INSTRUCTIONS BEFORE USE. • The appliance has been designed for home use only and must not be used for commercial or industrial purposes. DANGER FOR CHILDREN • Do not leave the packing near children because it is potentially dangerous. •...
  • Page 4 • If an extension cord is absolutely necessary, a 10 ampere (Europe) or 15 ampere (America) cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. •...
  • Page 5: Before Ironing

    BEFORE IRONING Ensure that the safety cap on the boiler is well tightened. Turn the cap until it stops and then tighten slightly without applying too much strength to avoid breaking the gasket, which would cause the steam to leak out. HOW TO PRIME THE BOILER - Fill with water using measuring cup.
  • Page 6 This symbol on label means: this article cannot be ironed! (e.g. chlorofibre, elastodiene). DRY IRONING CHART HOW TO STORE EUROSTEAM EVOLUTION IRON - Switch off the iron by turning the thermostat knob to “MIN”. - Disconnect the plug from the outlet.
  • Page 7 TROUBLESHOOTING Problem Question Solution The iron doesn’t make steam Have you put the water in the boiler? Put the water in the boiler Have you plugged the iron in? Plug the iron in Is the knob on the max temperature? Rotate the knob to the max position Is the knob hard or locked or already in Contact an Authorized Service Centre...

Table of Contents