Advertisement
STEP 2 - Background LED Controller Installation
1. Choose a cabinet/stand location (on or under) that is free of
excessive moisture and will allow for direct line of site for IR
sensor (located on controller).
2. Connect LED light to controller using USB plug. Mount controller
to aquarium cabinet using attachment tape included.
3. Plug in 12V DC power supply into a GFCI approved outlet and
ensure a drip loop is in place for all cables
STEP 3 - Controlling the Serene LED Background Light
BRIGHTNESS
CUSTOM
COLOR
RGB ADJUST
POPULAR
STATIC
FUCHSIA
COLORS
RGB FADE
BLUE to
AQUA
RED to
BLUE
STATIC COLOR METHOD 1:
Press any static color, then adjust using the RGB keys to adjust to color (0%,25%,50%,75%,100%).
When color spectrum desired is reached, press and hold the "M" key for 5 seconds, light will blink.
RGB FADE METHOD 2:
Press the RGB Fade key, colors will rotate through spectrum. When the desired spectrum is reached,
press the RGB Fade key again to pause. Press and hold the "M" key for 5 seconds, light will blink.
USING SERENE LED BACKGROUND LIGHT WITH A 24 HOUR TIMER
The Serene LED Background light is compatible with most 24 hour automatic wall timers and
our Single Ramp Timer in On/Off mode. An internal flash memory saves the last setting on the
Background light. To use with timer:
1. Plug 12VDC power supply into 24 Hr. timer.
2. Follow timer instructions to program on/off times.
3. When timer is in "on" mode, select background fade desired or press Custom Color "M".
4. Simply leave background light in this mode and timer will turn on/off daily as programmed.
ON/OFF
TURN LIGHT ON/OFF
ADJUST BRIGHTNESS/INTENSITY
SUN
ICE
RED
BLUE
RED to
ORANGE
BLUE to
ORANGE
PURPLE to
GREEN
(see warranty page for drip loop).
Remove clear tape at bottom of remote to activate
battery connection, then press ON/OFF key.
To adjust the intensity of any solid color or fade mode,
simply press the BRITE+ key and adjust to 50% or 100%.
POPULAR STATIC COLORS
Press a static color at any time to use as a base color
or bring attention to your aquascape!
RGB ADJUST
Use to adjust custom color (see below).
COLOR FADE PROGRAMS
Select any color fade program and light will slowly fade
through the selected color spectrums. Press RGB Fade
to gently fade through all color spectrums.
CUSTOM STATIC COLOR (M)
You can use one of two methods to save a custom color:
r
Integrated
IR Sensor
0%, 25%, 50%, 75%, 100%
Advertisement
