Table of Contents
Advertisement
3.1. WIFI CONFIGURATION OF THE GATEWAY
In case you would like to connect the gateway device to the home network router by
using WiFi connection, please follow next steps:
1.
After powering up, the gateway enters AP (Access Point) mode if Ethernet cable
is not connected. In AP mode LED will blink blue. In this mode gateway creates
its own WiFi network that allows the end user to configure it for connection to
home network router over WiFi (gateway's SSID or network name is located on
the label on the backside of the device)
2.
Connect your client device (PC, tablet or smart phone) to the WiFi network
created by gateway
3.
In web browser of your client device launch default IP address printed on the
label on the backside of the gateway (typically 192.168.1.1). Device information
page, should be displayed as shown in Illustration 4
In main menu, select "WiFi configuration" page as shown in Illustration 5, after
4.
which gateway should list all available WiFi networks in your home
Illustration 4: Device information
Illustration 5: WiFi configuration
7
Hide quick links:
Advertisement
Table of Contents
