Table of Contents
Advertisement
FINAL AMPLIFIER MOUNTING
STEP 2 – FINAL FITTING THE DUAL AMP PLATE
Carefully place the amplifier plate into position as shown in Figure 20-4. Be sure the wiring harness and
connectors are all intact and nothing has come unplugged.
•
if you have the Dynamix
bolts to securely mount the dual amp plate. This is shown in Figure 20-4.
®
•
If NO Dynamix
ECU or OEM amplifier bracket - Secure the dual amplifier plate. Simply substitute the
(2) 10mm screws in Figure 20-4 and use the two (2) T40 screws provided with the MB Quart Stage 5 kit
to securely mount the dual amp plate
STEP 3 – SECURE WIRING HARNESS
Secure the wiring harness with zip-ties to complete the installation. Ensure the routing of the harness avoids
contact with any sources of heat or moving parts.
Should the Dynamix ECU or OEM amplifier (if present) ever need servicing, be sure to leave enough slack
in the harness so that the dual amp plate can be removed and either set aside or flipped over as it was
during initial fitting on page 14.
(2018.5 Turbo S & 2019+ Models Continued)
Figure 20-4
10mm
®
ECU and/or OEM amplifier bracket - Tighten the remaining two (2) 10mm
10mm
27
Advertisement
Table of Contents
