MB QUART MBQR-STG5-2 Installation Manual page 19

MOUNTING THE KICK PANEL SPEAKERS (Continued)
STEP 6 – PLACE PASSENGER SIDE KICK PANEL
Place passenger side kick panel pod in its location as shown in
Figure 14-5. Ensure the positioning lines up with the holes you've
drilled.
STEP 7 – PUSH OUTER BOLTS THROUGH FENDER AND
MOUNT DRIVER'S SIDE KICK PANEL
With the included hardware push (1) bolt and (1) washer through
the inner passenger side fender well into the threaded insert of the
driver's side kick panel pod. This leaves only the head of the bolt
visible behind the tire.
Once the first bolt and washer are threaded in, insert and thread
the second bolt and washer for a total of two bolts/washers
attaching the kick panel pod to the passenger side fender well as
shown in Figure 14-6.
NOTE - Make sure that the wires behind the subwoofer enclosure
on the passenger side remain accessible for connecting to the
amplifier harness. Use some painters tape to keep them from
getting blocked by the enclosure if necessary.
STEP 8 – CONNECT WIRE HARNESS INTO KICK PANEL
Connect the wire harness from the amplifier that you routed earlier to the wire harness from the passenger
side kick panel.
● SOLID GRAY - Right Front Speaker +
● GRAY/BLACK - Right Front Speaker -
● RED - Illumination + (Optional Optional LED Light Ring Required)
● BLACK - Illumination -
Thread bolts/washers into kick panel pod
19
Figure 14-5
Figure 14-6