Honda 2007 Acura RL User Manual page 76

2005-08 ACCESSORIES AND EQUIPMENT Navigation System - RL
After troubleshooting, enter the navigation system anti-theft codes.

Verify that the correct navigation unit is installed for this model. Go into

the diagnostic mode and use "Version" (see VERSION ).
Always make sure that the correct DVD color and version are installed.

Check on-line for service bulletins or other service information for the

navigation system.
Perform the "Navi System Link" check (see NAVI SYSTEM LINK ) to check the communication line
between the PCM (FI-ECU) and the navigation unit.
1. Start the engine.
2. Go into the diagnostic mode and use "Trip Information" diagnostic under Functional Setup (see
FUNCTIONAL SETUP ).
Are the values greater than zero?
YES - The system is OK.
NO - Check for B or F-CAN DTCs, then troubleshoot them.
REARVIEW CAMERA IMAGE DOES NOT COME ON OR WORK PROPERLY
1. Turn the ignition switch ON (II), and start the engine.
Does the Navigation screen come on and show an image when the vehicle is started?
YES - Go to step 2.
NO - Go to troubleshooting for "NO PICTURE IS DISPLAYED" .
2. Go into the diagnostic menu and use the "Navi System Link" test (see NAVI SYSTEM LINK ) to
check the connection between the navigation unit and the rearview camera. (If there is no "R-camera"
link in the "Navi System Link" test, go to step 11).
Is the "R-camera" link red on the screen?
YES - Go to step 3.
NO - Go to step 10.
3. Check the connections between navigation unit connector G (7P) and the rearview camera connector
(6P).
Are the connections OK?
YES - Go to step 4.
NO - Reconnect the connectors.
2007 Acura RL