Honda 2007 Acura RL User Manual page 109

2005-08 ACCESSORIES AND EQUIPMENT Navigation System - RL
3. Press the EJECT button (B).
4. Remove the DVD-ROM/CD-ROM.
5. Insert the new DVD-ROM/CD-ROM with the white label facing up.
6. Close the front cover. Do not turn the ignition switch OFF; watch the navigation screen until the data
is downloaded to the navigation unit.
7. Do the Map Matching (see MAP MATCHING ).
NOTE: After servicing, the front cover and PC card slot door must be closed.
NAVIGATION UNIT REMOVAL/INSTALLATION
NOTE:
Before you replace the navigation unit, back-up the client data using

system diagnostic mode "save users memory" ('07 and later) under the
functional set up (see FUNCTIONAL SETUP ).
If the navigation unit is replaced or disconnected, a Map Matching must

be done (see MAP MATCHING ).
1. Turn the ignition switch to ON (II).
2. Eject the DVD from the original navigation unit (see DVD-ROM/CD-ROM REPLACEMENT ). To
avoid scratching or damaging the DVD, temporarily place the DVD in a jewel case.
3. Turn the ignition switch to LOCK (0).
4. Remove the trunk trim lining (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
5. Remove the four screws (A) from the navigation unit brackets (B).
Fig. 98: Identifying Screws, Navigation Unit Brackets And Navigation Unit Connectors
Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Disconnect the navigation unit connectors (C).
7. Remove the navigation unit (D).
8. Install in the reverse order of removal.
9. Turn the ignition switch to ON (II), then reinstall the client's original DVD, verifying that the DVD is
free of scratches or smudges.
2007 Acura RL