Table of Contents
Advertisement
Q u i n t e z z
ATTENTION: The first time the QUINTEZZ is switched ON, it can take about 15 minutes to catch the
satellites.
C.
SPEED INDICATION
The display indicates the real speed in Km/h.
The QUINTEZZ is the perfect solution to prevent you from speeding a few kilometres by accident.
You simply enter a maximum speed on the QUINTEZZ. As soon as you exceed that speed, you will
get a warning ('Speed Alert').
D.
SETTING THE MAXIMUM SPEED
•
The maximum speed can be set by shortly pressing the 'setting' button during operation in
the car.
•
The display will now show the set maximum speed.
•
With the 'Memory
button you can lower it.
•
If the maximum speed is set at 0 Km/h, the speed alert is switched off.
E.
COMPASS
The QUINTEZZ is also equipped with en electronic compass with a capacity of 8 different directions
(N – NE – E – SE – S – SW – W – NW). This is visualized in the compass rose of the QUINTEZZ.
This compass prevents you from loosing your sense of direction in unknown areas.
F.
INDICATION OF DANGEROUS LOCATIONS
It is important for your safety that dangerous locations are indicated. On a location where speed
controls are organized, sometimes people hit the brakes unexpectedly. Therefore, these locations
are indicated by the QUINTEZZ 500 metres ahead. Mobile controls are not performed on a fixed spot,
and therefore are not indicated by the QUINTEZZ. The advanced processor controlled GPS system
does not only record the location as such, but also the traffic stream. If there is a dangerous location
on the uphill carriageway, no warning will be given on the downhill carriageway. This function is
important in order to avoid any false alarms. The audiotext in case of a dangerous location can be:
'Camera', 'Two way Camera', 'Dangerous Location', 'Track control', 'Track control end', 'Warning
One', 'Warning Two'. Next to the spoken text, you will also hear a ringer sound, the LED with the
letter 'S' (for System data) will light up and the distance in meters to the location is descending.
G.
ENTERING/DELETING A NEW LOCATION
You can manually add and delete locations from the QUINTEZZ memory. These locations are called
'Users data' and can be exchanged with other people using the QUINTEZZ through the forum on
www.quintezz.com.
•
If you want to manually add a location, you are to shortly press the 'Memory' button on that
location.
•
The QUINTEZZ will confirm the saving of this location by stating 'Saving Data'.
•
It is possible to delete a manually added location.
•
To this effect, the 'Memory' button is to be pressed on the respective location. The location
is then deleted.
•
The deleting process is confirmed by stating 'Deleted Data'.
•
The memory for users data has a capacity of 500 locations.
If it is not possible to save data, the message 'Not saved' will appear.
•
The manually entered locations are indicated with the text 'Watch out'. Also a ringing signal
is heard, the letter 'U' (for Users data) will light up and the distance in meters to the location
is descending.
A.
INTRODUCTION
The supplied CD-ROM contains software to exchange data between the QUINTEZZ
English
' button you can raise this setting in 10 km/h steps, and with the 'Mute
PC OPERATING THE QUINTEZZ
4
'
Advertisement
Table of Contents
