Table of Contents
Advertisement
5. 3. 2. 3 FUNCTIONING IN CASE OF POWER FAILURE
1. Manual open:
In case of power failure E-MOTION automatic control allows the door to be opened manually just with a
push, obtaining a simple opening.
5. 3. 3 USE RESTRICTION
It's useful to show, assist and advise the client on the correct use of internal sliding doors with
E-MOTION automatic control, if they are installed where there are people with physical, sensorial
and mental reduced capacities, children and old people.
Do not allow children to play in the door passage, and keep the remote control out of their reach.
5. 4 MAINTENANCE
The product doesn't need particular periodic maintenance operations. It's necessary, under the
§ 4.2 of EN 16005 law, verifying at least once a year the correct functioning of the security
devices.
5. 5 PROBLEMS AND SOLUTIONS
PROBLEM
"On / off" button light doesn't
switch on.
The door doesn't move and no
light switches on.
The door doesn't move and
the lights switch on in start-up
sequence.
INSTALLATION, OPERATION AND MAINTENANCE
MANUAL E-MOTION AUTOMATIC CONTROL
POSSIBLE CAUSE
The automatic control isn't
connected to the power grid
(connector, direct terminal box,
thermic connection / differential,
etc.)
Defective internal connection.
The fuse is burned.
The switch isn't on ON position.
The system isn't powered (internal
failure).
Defective motor connection.
EC_MAN_IST_022
Rev. 5
EN
SOLUTION
Control the connection and verify the
correct voltage, 230V - 50Hz.
Control the internal connection.
IMPORTANT! Carry out these
operations with the guide
disconnected!
Verify the fuse with a tester.
Move the switch on ON position.
Contact the technical staff.
Contact the technical staff, control
internal connections between
motor and control card.
35
Advertisement
Table of Contents
