Weslo Cadence 925 User Manual page 8

DIAGRAM OF THE CONSOLE
Speed Control
CAUTION:
console, read the following precautions.
¥ Do not stand on the walking belt when turn-
ing on the power.
¥ Always wear the clip (see the drawing
above) while operating the treadmill. When
the key is removed from the console, the
walking belt will stop.
¥ Adjust the speed in small increments.
¥ The training zones marked below the speed
control are general guidelines only. See
page 14 or more information.
¥ To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable
water bottle.
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.) In addition,
make sure that batteries are installed in the console.
(See step 6 on page 6.) If there is a thin sheet of clear
plastic on the console, remove it.
Step onto the foot rails of the treadmill. Next, find the
clip attached to the key (see the drawing above). Slide
the clip onto your waistband.
Before operating the
Monitor Display
Key
Follow the steps below to operate the console.
Insert the key fully into the power switch.
1
Note: Inserting the key
will not turn on the dis-
plays. The displays will
turn on when the
DISPLAY button is
pressed or when the
walking belt is started.
If you just installed bat-
teries, the displays will already be on.
Reset the console and start the walking belt.
2
Move the speed
control to the
RESET position.
Note: Each time
the walking belt
is stopped, the
speed control
must be moved to the RESET position before
the walking belt can be restarted.
Next, slowly move the speed control until the
walking belt begins to move at slow speed.
Carefully step onto the walking belt and begin
exercising. Change the speed of the walking belt
as desired by moving the speed control.
To stop the walking belt, step onto the foot rails
and move the speed control to the RESET position.
8
Pulse Display
Pulse Sensor
Clip