Page 1
Model No. WCTL90063 Serial No. Serial Number Decal QUESTIONS? As a manufacturer, we are commit- ted to providing complete cus- tomer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee you complete satisfac- tion through direct assistance from our factory.
TABLE OF CONTENTS IMPORTANT PRECAUTIONS ..............2 BEFORE YOU BEGIN .
Page 3
15. The treadmill is capable of high speeds. 20. When folding or moving the treadmill, make Adjust the speed in small increments to sure that the storage latch is fully closed. avoid sudden jumps in speed. 21. Inspect and tighten all parts of the treadmill 16.
And when ing. The model number of the treadmill is WCTL90063. you’re not exercising, the unique CADENCE 927 can The serial number can be found on a decal attached to be folded up, requiring less than half the floor space of the treadmill (see the front cover of this manual for the other treadmills.
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires two adjustable wrenches (not included). A phillips screwdriver (not included) may also be needed. 1.
Page 6
5. Move your right hand to the position shown at the right, and hold the treadmill firmly. Raise the treadmill until the Storage Latch (50) closes over the Frame Guide (52) (see the inset drawing). Make sure that the Storage Latch closes fully over the Frame Guide.
OPERATION AND ADJUSTMENT THE PERFORMANT LUBE WALKING BELT ment-grounding conductor and a grounding plug. Plug the power cord into a surge protector, and plug the surge protector into an appropriate outlet that is Your treadmill features a walking belt coated with properly installed and grounded in accordance PERFORMANT LUBE , a high-performance lubricant.
Page 8
DIAGRAM OF THE CONSOLE Monitor Displays Speed Control Pulse Sensor Note: If there is a thin sheet of clear plastic on the face of the console, remove it. Clip BATTERY INSTALLATION CAUTION: Before operating The console requires three “AA” batteries (not in- the console, read the following precau- cluded);...
STEP BY STEP CONSOLE OPERATION Follow your progress with the monitor displays. • PULSE/CAL./FAT CAL. Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.) This display shows the approximate num- Step onto the foot rails of the treadmill.
Measure your pulse, if desired. To decrease the in- cline, stand with your left foot to- To use the pulse Pulse wards the front of sensor, stand on Sensor the foot rails and the left foot rail. place your thumb Using your right foot, on the pulse sen- press down the foot...
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, unplug the power cord. Caution: You must be able to safely lift 45 pounds (20 kg) in order to raise, lower, or move the treadmill. 1.
2. Hold the treadmill firmly with both hands, and lower the treadmill to the floor. To decrease the possibility of in- jury, bend your legs and keep your back straight. TROUBLE-SHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed.
Page 13
3. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY a. Check the batteries in the console. (See BATTERY INSTALLATION on page 8.) Most problems are the re- sult of drained batteries. 4. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON a.
CONDITIONING GUIDELINES Fat Burning WARNING: Before beginning To burn fat effectively, you must exercise at a relatively this or any exercise program, consult your low intensity level for a sustained period of time. During physician. This is especially important for in- the first few minutes of exercise, your body uses easily dividuals over the age of 35 or individuals accessible carbohydrate calories for energy.
Page 15
Training Zone Exercise to cool down. This will increase the flexibility of your muscles and will help to prevent post-exercise problems. After warming up, increase the intensity of your exer- cise until your pulse is in your training zone for 20 to Exercise Frequency 60 minutes.
Friday, 8h00 until 18h30 Eastern time (excluding holidays). When ordering parts, please be prepared to give the following information: • The MODEL NUMBER OF THE PRODUCT (WCTL90063). • The NAME OF THE PRODUCT (WESLO ® CADENCE 927 treadmill). • The SERIAL NUMBER OF THE PRODUCT (see the front cover of this manual).
Page 19
REMOVE THIS PART LIST/EXPLODED REMOVE THIS EXPLODED DRAWING DRAWING FROM THE MANUAL! AND PART LIST FROM THE MANUAL Save this EXPLODED DRAWING and PART LIST for future reference. Note: Specifications are subject to change without notice. For information about ordering replacement parts, see page 17 of the User’s Manual.