Weslo Cadence 925 User Manual page 6

3. Carefully rotate the Console Base (45) to the posi-
tion shown. Tighten four Handrail Screws (85) into
the Console Base and the Upright (37) as shown.
Refer to the inset drawing. Tighten the four Handrail
Screws (85) that are already in the Upright (37).
Tighten all eight Handrail Screws (85) as tightly
as possible. Carefully lift up and push down on
the handrails to make sure that the Console Base
(45) does not move. Regularly inspect and tight-
en all eight Handrail Screws.
4. Attach the Frame Guide (66) and the Frame Guide
Spacer (84) to the left side of the Frame (21) with
two Frame Guide Screws (77) as shown. Note: Be
careful not to overtighten the Screws. Make sure
that the thick end of the Frame Guide is at the
bottom.
5. Remove the backing from the Adhesive Clip (2).
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.
6. The Console (49) requires two "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the neg-
ative (Ð) ends of the batteries touching the springs.
Close the Battery Cover.
7. Make sure that all parts are properly tightened
before you use the treadmill. The use of the remain-
ing parts will be described in other sections of this
manual. To protect the floor or carpet from dam-
age, place a mat under the treadmill.
3
85
Handrails
85
4
77
66
Thick end
5
6
Batteries
6
45
85 85
37
45
85
85
37
84
21
37
2
35
49
48
85
85