Spotlight PIC HS Quick Start Manual

Followspot/steel
Line
Mod.PIC HS
WARNING!
ALWAYS
CONNECT THE
PROJECTOR TO A
MAIN WHICH IS
PROTECTED BY A
SUITABLE
ELECTRIC FUSE
SELECTED
ACCORDING TO
THE
INSTRUCTIONS
I - DESCRIPTION OF THE PROJECTOR
1. Suspension clamp
2. Accessory guides
3. Accessory locking spring
4. Lever handle for adjusting inclination of projector
5. Lamp holder tray access knob
6. Lamp position adjustment knob
7. Screws to adjustlamp
8. Safety chain anchorage clamp
9. Wing nut for locking and adjusting projector focus
10. Lever handle for lens adjustment (Zoom)
11. N° 4 levers for flaps adjustment
II - GENERAL
The projector you have bought satisfies directives
73/23/EEC as it complies with standards EN 60598-1
and EN 60598-2-17.
model
maximum supply voltage in V
maximum power of the projector in W
the index of protection IP
maximum temperature of the environment admitted
in °C
maximum temperature of the projector body in °C
minimum distance from any inflammable surface
information to find the position 0° of the projector:
when the tip of the arrow points upwards
maximum angle of inclination upwards and
downwards. These limits, imposed by the lamp
manufacturer, should not be exceeded as they
would reduce the projector's useful life or lead
to its deterioration.
III - INSTALLATION
The projector can be either suspended or mounted on a
stand.
WARNING!
DO NOT INSTALL THE PROJECTOR ON SURFACES
WHICH ARE USUALLY INFLAMMABLE.
The minimum distance at which the projector must be kept
from easily inflammable surfaces is indicated on the label.
The safety norms estimate that a metal wire screen be
mounted on the front of the projector to prevent any large
glass fragments from falling if the projector breaks.
WARNING!
REPLACE THE LAMP AND/OR LENS IF VISIBLY
DAMAGED.
For safety reasons always use the safety chain between the
projector and the suspension truss.
3.1 - Accessories
The accessories estimated for this projector are listed in the
price list and can be mounted by inserting into guides 2.
1