Thread Tension Adjustment - TECHWOOD TMAC-1096 Instruction Manual

1.Put the bobbin on the Spool Pin (22), shown in Fig 1.
2. Wind the thread of the bobbin through the clamp above winding slice (5), shown
in Fig2.
3. Put the winding pin(35) shown in Fig3.
4. Insert the empty bobbin onto winding pin(35), shown in Fig4.
5. Wind the thread that passed through the clamp above winding slice (5) on the
empty bobbin for several cycles, shown in Fig5.
6.Trun "ON" power, shown in Fig6.
10. Stamp foot switch (31) to start winding, shown in Fig7
11. The empty bobbin will move to left automatically under the impact of stop
block after winding full, shown in Fig11.
12.Release foot switch and the sewing machine will stop. Cut thread end from the
winded bobbin.

Thread Tension Adjustment

Just as shown in the right Fig., it requires a slight
adjustment to the thread tension due to different
sewing texture's flexibility, texture material, sewing
thickness, and texture layers. The thread tension
adjustment wheel (8) is used for adjust thread tension.
(Shown in right Fig)
Please refer to the following pictures for adjustment on
thread tension
15