Introduction To Applicable Functions - TECHWOOD TMAC-1096 Instruction Manual

1. Lift presser foot and hold the upper thread by hand with a extraction length of
about 10cm, shown in Fig1.
2. Take down transparent cover (18), shown in Fig2.
3.Put the bobbin (33) into the rotating shuttle of bobbin thread, shown in Fig3.
4. Extraction the thread length about 10CM.
Attention:​ Make sure the clockwise direction of
the thread end in putting the bobbin, shown in the right
Fig:
5. Pull out 10cm thread end from the bobbin thread bobbin, shown in Fig5.
6. Put the pulled bobbin thread and upper thread to the left by left hand, shown in
Fig 6.
7. Rotate counter clockwise the hand wheel (24) to make the needle move up and
down after the bobbin thread and upper thread put to the left, shown in Fig7.
8. Hold upper thread by left hand during rotating the hand wheel (24) to make the
needle move up and down, pull on the upper thread to bring the lower thread up,
pull both thread to the back under the presser foot ,pull out 10cm shown in Fig8.
9. Put on the transparent cover (18) after the bobbin
thread and upper thread pressed under the presser
foot (17), shown in Fig 9.

Introduction to applicable functions

1. Please in strict accordance with the following steps in sewing.
11