Advertisement
TROUBLESHOOTING
PROBLEM
The GN remote doesn't control
the IS-1000.
The CD Player doesn't work.
The CD Player doesn't read the
CD.
The digital RCA output doesn't
work.
The CD Player is not performing
at the best.
CAUSE
The GN remote can be used to
control more than one unit.
To control each unit the correct
mode must be selected on the
remote.
The batteries are too low.
The CD Player doesn't receive
power.
The CD Player is in protection
mode due to improper use or due
to unstable power supply.
The protection FUSE is blown.
The CD is not correctly inserted.
The CD is too dirty or ruined to be
read.
The CD is stuck inside the tray.
The CD format is not compatible.
The connection cable used is not
a 75ohm digital cable.
Your AC power system is not
grounded.
The CD Player is not properly
levelled on a flat surface.
SOLUTION
Select CD mode on the remote.
The button "CD" is located in the upper part of
the remote.
See page 7 for more information.
Replace the batteries in the remote.
Make sure the power cord is properly connected
to the CD Player and to the power socket.
Turn OFF the unit using the MASTER SWITCH on
the rear panel and wait 30 seconds before
switching it ON again.
Call a certified Gold Note dealer to schedule a
service operation. Do not attempt to replace the
blown fuse on your own.
Make sure the CD is properly inserted and with
the label/printed side facing up.
Check the CD for scratches and dirt, try to clean
the CD using a soft dry cloth.
Contact a certified Gold Note dealer to remove
the CD and check the unit for damages.
The CD Player is designed under the RED BOOK
standard technology. Always verify that the CDs
are compatible with the unit.
Use a 75ohm digital cable.
Contact a certified dealer for assistance.
Make sure the unit is perfectly levelled with the
help of a spirit level or a high precision level.
10
Advertisement
