Advertisement
Quick Links
Models:
MW1230B
MW1230BE
MW1330H
MW1330HE
READ ENTIRE MANUAL BEFORE ATTEMPTING TO OPERATE MACHINE!
If incorrectly used this machine can cause severe injury. Those who use and maintain this ma-
chine should be trained in its proper use, warened of its dangers, and should read the entire
manual before attempting to set up, operate, adjust, or service this machine.
The engine exhaust from this product contains chemicals known to the State of
California to cause cancer, birth defects, or other reproductive harm.
IMPORTANT: THIS UNIT IS EQUIPPED WITH AN INTERNAL COMBUSTION ENGINE AND SHOULD NOT BE USED ON OR NEAR
ANY UNIMPROVED FOREST COVERED, BRUSH COVERED, OR GRASS-COVERED LAND UNLESS THE ENGINE'S EXHAUST SYS-
TEM IS EQUIPPED WITH A SPARK ARRESTER MEETING APPLICABLE LOCAL LAWS (IF ANY). IF A SPARK ARRESTER IS USED,
IT SHOULD BE MAINTAINED IN EFFECTIVE WORKING ORDER BY THE OPERATOR.
IN THE STATE OF CALIFORNIA, A SPARK ARRESTER IS REQUIRED BY LAW (SECTION 4442 OF THE CALIFORNIA PUBLIC
RESOURCES CODE). OTHER STATES MAY HAVE SIMILAR LAWS. FEDERAL LAWS APPLY ON FEDERAL LANDS. SEE YOUR
AUTHORIZED SERVICE CENTER FOR A SPARK ARRESTER.
Maxim EZ Walk
WARNING!!
Advertisement
Related Manuals for Maxim EZ Walk MW1230B
Summary of Contents for Maxim EZ Walk MW1230B
- Page 1 Maxim EZ Walk Models: MW1230B MW1230BE MW1330H MW1330HE WARNING!! READ ENTIRE MANUAL BEFORE ATTEMPTING TO OPERATE MACHINE! If incorrectly used this machine can cause severe injury. Those who use and maintain this ma- chine should be trained in its proper use, warened of its dangers, and should read the entire manual before attempting to set up, operate, adjust, or service this machine.
- Page 2 IMPORTANT RULES FOR YOUR SAFETY Before operating this machine read all the instructions for safe operation and the engine manual!! TRAINING engine can collect. It contains carbon monoxide which is a • Read the Owner’s Manual carefully. Be thoroughly familiar tasteless, odorless, poisonous gas.
-
Page 3: Setup Instructions
SET UP INSTRUCTIONS MAXIM EZ WALK (Models MW1230B, MW1330H, MW- 1230BE, MW1330HE) IS FULLY ASSEMBLED EXCEPT FOR HANDLES. 1. Remove top boards of crate. 2. Retrieve hardware bag from crate. Bag will contain the following: Quantity 6 -- 5/16 X 3/4 bolts... -
Page 4: Starting And Stopping Engine
STARTING AND STOPPING ENGINE BEFORE STARTING THE ENGINE READ ENGINE MANUAL BEFORE STARTING THE ENGINE. 1. Remove the oil-fi ll cap and fi ll the crankcase with oil. Use a high quality detergent oil classifi ed ‘For Service SC,SD,SE or MS. In temperatures above 40 degrees F. (4.4 degrees C) use SAE 30. If not available, use SAE 10-W. -
Page 5: Operation
TO START ENGINE 1. Check fuel supply and oil level. 2. Put in neutral gear. 3. Move throttle to START or choke position. ELECTRIC START MODELS Insert key in switch and turn to start. As soon as engine starts release key. Do not keep on ‘start’ for more than 10 seconds. -
Page 6: Maintenance
MAINTENANCE IMPORTANT! WEAR GLOVES FOR CLEANING OR FOR ANY MAINTENCE ON BLADES. WRAP THE BLADE WITH NEWSPAPER OF OTHER MATERIAL FOR MAINTE- NANCE. BEFORE ATTEMPTING TO REMOVE BLADE, ALWAYS DISCONNECT SPARK PLUG WIRE TO PREVENT ACCIDENTAL STARTING. BLADE Blades should be replaced if bent or chipped. If a blade becomes dull it should be sharpened or re- placed. - Page 7 Give product MODEL NUMBER, NAME, and SERIAL NUMBER. • Order by quantiy desired, part number and description of parts. Send Fax Orders to: Address mail orders to: Maxim Manufacturing Corporation 601.625-8227 Attention: Parts Department Phone orders may be placed by calling P. O. Box 110 800.621.2789...
- Page 8 Part Number Description Quantity 272216 Belt, 31” # 6-8048 272217 Belt, 74” 336658 Engine Pulley, 4” C/Iron 336668 Pulley 3-1/2”, Blade Hub & Eng. 359404 Spacer, MTR Pulley-Keyway 359768 Clevis Pin, 5/16” x 2” 360507 Lift Connector, Rear- Paint 360508 Lift Leaver- Paint 360513 Belt Cover- Paint...
- Page 9 350450 Washer, Blade Bolt -Punch 359721 Brake Band (3501) 360500 Deck Weldment (30”) -Paint 360519 Hub Plate -Paint 360525 Deck Bracket, Chute -Paint 360529 Belt Guide, Deck -Paint 400179 Capscrew, 5/16” x 1/2” NC2 400223 Bolt, Center Blade 7/16” x 1-1/2” 400265 Capscrew, 3/8”...
- Page 10 360501 Uni-Body, Rear Wldt -Weld 360514 Shifter Link Assy -Paint 360526 Anchor Plate -Paint 360527 Belt Guide, Engine -Paint 360528 Belt Guide, Transaxle -Paint 360530 Input Coupler Link -Paint 360531 Brake Band Support 360532 Debris Shield 360536 Push Rod Assy -Assemble 400111 Capscrew, 1/4”...
- Page 11 Limited Warranty Maxim Manufacturing Corporation, through its dealers will repair or replace any part, or parts of the EZ Walk fram or handles that are defective in material, workmanship, or both. Transportation charges on parts submit- ted for repair or replacement under this warranty must be borne by the purchaser. The original sales receipt must be submitted as proof of purchase date.