Table of Contents
Advertisement
WARRANTY
Thank you for purchasing this Wells Manufacturing Co. appliance.
Proper installation, professional operation and consistent maintenance of this appliance will ensure that it
gives you the very best performance and a long, economical service life.
This manual contains the information needed to properly install this appliance, and to use and care for the
appliance in a manner which will ensure its optimum performance.
Electrical:
208 Volts, Single Phase 30 Amps
240 Volts, Single Phase 27 Amps
NOTE: Requires a dedicated 40 Amp circuit
Plumbing:
Water Inlet: 1/4" Male Flare Fitting
Supply: 1/4" Female Flare supplied by a 1/4" O.D. or larger water supply line
NOTE: If water supply run from main supply line to Water-Max™ exceeds 12 feet,
a 3/8" O.D. or larger water supply line is required.
IMPORTANT: This dispenser must be installed in compliance with all applicable
federal, state and local codes and ordinances.
Dimensions:
Height:
Width:
Depth:
Weight:
TABLE OF CONTENTS
INTRODUCTION
SPECIFICATIONS
32-5/8"
13-1/8" (with satellite installed)
20-3/4" (without satellite)
55 lbs. (heater assembly only, dry) 20 lbs. (satellite only, dry)
146 lbs. (operating configuration - filled, with satellite installed & filled)
62 lbs. (satellite only, filled)
1
xi
1
2
4
4
5
9
10
12
13
13
24" (with satellite installed)
Advertisement
Table of Contents
