Advertisement
ACWand Installation
1. Press and hold SW1, then connect the power adaptor to the device (while pressing).
2. Hold SW1 until a green LED turns on. It will enter Access Point mode. The Access Point
setting are:
a. SSID: "RolbitSetAP"
b. Password: "rolbit1234"
3. After the connection to AP has been made, open web browser and go to IP: 192.168.4.1
4. Press and hold SW1 and refresh the page at the same time. You will be redirected to the
following setup page:
Page 4 of 8
Advertisement
