Commands For Configuration - SCS Sentinel SCS1 COMFORT+ Manual

4.1 Commands for Configuration

Set up voice alarm phone
number
Syntax:
【3】
+ 【1-9】
+ 【phone number】
+ 【#】
delete voice alarm phone
number
Syntax:
【3】
+ 【1-9】
+ 【#】
Set phone number to
receive SMS message
Syntax:
【4】
+ 【1-6】
+ 【phone number】
+ 【#】
EN ::: 32
To set the 1st group to the 9th group of voice alarm phone number 【 1-9 】
indicates that the first group to the Nineth group alarm number correspondingly.
Example: If the user wants to set 13812345678 for the first set of voice alarm
phone number
Method one:
After you press the # key to enter the configuration mode, press the
3113812345678# , press * then press # to exit Setup.
Method two:
remote calling into the alarm panel put in password (initial password: 1234 )
when being asked, then press the # key, hear the voice prompt means the host
into setting state.
in remote setting, press a digital then the host will broadcast one digital speech,
if press a digital not broadcast speech or press once broadcast second speech
mean setting not correct. press* key to exit.
Method three:
Send SMS messages 12343113812345678# to a alarm panel (which at the
beginning of 1234 is the user password), the alarm panel will reply with SMS
message "Group 1 phone number :13812345678" to confirm the 1st group alarm
phone number is set to13812345678 successfully.
For users using the telephone line extension, you should dial a number (such as
"9") to pick up a dialing tone, then with your command you should add to this
number a " * ". So the completed command becomes 9*13812345678#
Remark:
7,8,9 group number for HELP SENIOR zone and panel will only dial these three
groups number when that specific zone alarming.
Used to delete the first groups to the Nineth group alert phone numbers
Example: If you want to delete the first set of telephone alarm number,
Method one:
After you press the # key to enter the configuration mode, press the 31# , then
press * then press # to exit Setup.
Method two:
after entering the telephone remote setting status, press 31#.
Method three:
Send SMS message 123431# on the alarm panel, alarm panel reply " group
1 phone number: " to confirm the 1st group alarm phone number has been
removed.
To set the first group to the sixth group of phone number for SMS message. When
alarm panel is alert, it sends a SMS message to the six sets of numbers one by
one.
Example: If the user wants to set 13812345678 SMS for the first group of SMS
message
Method one:
After press the # key to enter the configuration mode, press the 4113812345678#
, then press * then press # exit Setup
Method two:
after calling and connected to the panel from remote, press 4113812345678#
Method three:
Send SMS message 12344113812345678# to the panel.