®
R&S
SMBVB-K548
"Simple"
"Enhanced"
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:FILTer
Channel Spacing
Available for "Filter Mode > Simple".
Sets the channel spacing.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR:CSPacing
Signal Bandwidth
Available for "Filter Mode > Simple".
Sets the signal bandwidth. The value of the "Signal Bandwidth" should not be higher
than the "Channel Spacing".
User Manual 1179.0922.02 ─ 01
You can specify the RF bandwidth and channel spacing of the signal.
The lowpass filter is designed to pass through frequency components
inside the signal bandwidth and suppress components in the adjacent
channel.
Figure 4-1: Simple filter mode
In the enhanced filter mode, you can specify the passband and stop-
band frequencies of the lowpass filter.
Figure 4-2: Enhanced filter mode
Crest Factor Reduction Settings
on page 17
on page 17
13