®
R&S
SMBVB-K548
4 Crest Factor Reduction Settings
Prerequisite: An ARB file is loaded and enabled.
Access:
► Select the "Baseband > ARB > Crest Factor Reduction".
The remote commands required to define these settings are described in
"Remote-Control
Settings:
State.............................................................................................................................. 11
Generate
Algorithm....................................................................................................................... 12
Desired Crest Factor
Max
Original Crest
Resulting Crest
Filter
Channel
Signal
Stopband
Passband
Maximum Filter
State
Enables the crest factor reduction calculation.
Note: You cannot activate the crest factor reduction and the notch filter simultaneously.
Enabling the notched filter automatically disables the crest factor reduction.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR[:STATe]
User Manual 1179.0922.02 ─ 01
Commands",
Waveform...................................................................................................... 12
Delta............................................................................................12
Iterations................................................................................................................12
Factor..................................................................................................... 12
Factor.................................................................................................. 12
Mode.................................................................................................................... 12
Spacing...........................................................................................................13
Bandwidth.......................................................................................................... 13
Freqeuncy.....................................................................................................14
Freqeuncy.................................................................................................... 14
Order................................................................................................... 14
Crest Factor Reduction Settings
on page 15.
on page 16
Chapter 5,
11