Table of Contents
Advertisement
DANGER
The ramp in the transport position
represents a stored energy hazard and
if not secured can fall; injuring you or
bystanders.
Hold the ramp in place when removing
straps and use care to lower the ramp
carefully to the ground.
2.
Remove the pin on the hold down bar and lay
the chain and pin on the center of the trailer bed.
Slide the hold down bars apart.
3.
Start the machine according to the Operator's
Manual and disengage the parking brake.
4.
Raise the trencher arm into the transport
position.
5.
Slowly, while looking behind you and down,
move the machine down and off the ramp.
Removing the Trailer Hitch
1.
Park the machine and trailer on a level surface.
2.
Rotate the jack into the vertical position.
3.
Disconnect the wiring harness from the electrical
connector on the hitch. Place the connector into
the holster on the tongue.
4.
Remove the chains retaining the tongue to the
hitch.
5.
Remove the pin and lift the handle on top of the
hitch.
6.
With the tongue handle raised CHECK.
7.
Raise the tongue above the hitch and lower the
handle
8.
Install a pin (not included) to lock the handle.
9.
Chock the trailer wheels.
Maintenance
Checking Lug Nuts
Service Interval: After the first 10 hours/Monthly
(whichever comes first)
Torque the nuts to 68-102 N∙m (50-75 ft-lb).
9
Advertisement
Table of Contents
