Disconnecting From The Pc - Lenze EPM-H315 Operating Instructions Manual

5 Commissioning
Project transfer to the operating unit

Disconnecting from the PC

ENTER to download
System autotest OK
F6 F7
F1 F2
V W X Y Z –
7 8
M N O P Q R
4 5
D E F G H I
1 2
A B C
shift
0
How to download a project into the operating unit:
1. Switch on your PC and start the "HMI Designer" planning tool.
2. Switch on the supply voltage for the operating unit.
3. When the message ENTER to download" appears on the display, press the
enter key
The operating unit is ready to receive data when the message Boot forced"
appears on the display.
4. Load the desired project from the HMI Designer into the operating unit.
–
See "HMI Designer − Getting started" Manual.
After the download, the operating unit is ready for operation and can exchange
data with other stations via the system bus (CAN).
5.2.3 Disconnecting from the PC
How to disconnect from the PC:
1. Switch off the PC.
2. Switch off the supply voltage for the operating unit.
3. Unplug the EPZ−H111 programming adapter from the operating unit and
the EPZ−H110 download cable from the PC.
4. Switch on the supply voltage for the operating unit.
The operating unit is now ready for operation.
62
F8 F9 F10
F3 F4 F5
PgUp
+ / -
Info
9
PgDN
S T U
Help
6
J K L
3
·
0
Clr
± space
Esc
Enter
0 of the operating unit.
Boot forced
l
h315_007
EDBPM−H315 DE/EN/FR 7.1