Advertisement
17.
Use this appliance only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock or injury to persons.
18.
Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
14 gauge minimum size and rated not less that 2025 watts. The extension cord must
be a three wire cord with grounding type plug and cord connector. The extension
cord shall not be more than 20 feet in length.
SPECIFICATIONS
Dimensions LxWxH
Net Weight
Frequency
Heater Rating
ELECTRICAL CONNECTION
A 15 Amp, 110 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this
appliance. The fireplace must be on a dedicated circuit as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in opera-
tion. The unit comes standard with a 6.5 ft long 3 wire cord, exiting out the back of the
fireplace. Plan the installation to avoid the use of an extension cord. If an extension cord
must be used, it must be a minimum 14 gauge, 3 wire with grounding type plug and
connector and rated not less than 2025 watts. The extension cord shall not be more than
20 ft in length.
WARNING:
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING:
qualified service technician to inspect the fireplace and replace any part of the electrical
system which has been wet.
Voltage
Watts
Electrical outlet wiring must comply with local building codes and other
Do not use this fireplace if any part of it has become wet. Immediately call a
10"x6.35"x21.67"
28.7 lbs
110-120V
60 Hz
1350 W
4600 BTU
Advertisement
