Troubleshooting - Grizzly GHS 2842 B Translation Of The Original Instructions For Use

The stated vibration emission value was meas-
ured in accordance with a standard testing
procedure and may be used to compare one
power tool to another.
The stated vibration emission value may also
be used for a preliminary exposure assess-
ment.

Troubleshooting

Problem
Motor not running or cuts
out during operation
Garden waste is not
drawn in
Shredding material
comes out in chains
Possible cause
Collection box
incorrectly attached
Overload protection
No mains power supply
Safety switch is not
properly in place on the
collector box
Cylinder running in
reverse
Shredding material is too
soft
cylinder is jammed
Pressure plate is incorrectly
adjusted
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which the
power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage conditions
(all parts of the operating cycle are to
be considered, including, for example,
times during which the power tool is
turned off and times when the tool is
turned on but is running idle).
Remedy
Push the collection box
home to its correct
position, and place the
safety switch on the box to the ON
position.
To switch back on, start by turning the
operating mode selection switch (
to the "OFF" position.
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Move the safety switch into
the ON position (see
section on emptying the
collector box)
Change rotational direction using
the switch
Insert wood or shred dried branches
Free up the jam
(See section on working methods)
Readjust the pressure plate (See
section on working methods)
GB
9)
A
7).
A
83