Troubleshooting - Grizzly EMH 2440 Translation Of The Original Instructions For Use

GB
Do not exceed the maximum permitted
network impedance of 0,30 Ohms at the
electrical connection point. To be on the
safe side, check with your local electric
utility to verify that the junction point of the
mains has enough continuous current car-
rying capacity for the unit.
Noise and vibration values were deter-
mined according to the standards and

Troubleshooting

Problem
Motor will not
start
Garden waste is
not drawn in
Unit won't shred
properly
80
Possible cause
No mains power
supply
Overload protection tripped
Lid of housing not closed
properly
Shredding material is too
soft
Unit blocked
Shredding material in
discharge duct
Blades are blunt
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.
Remedy
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Wait until the motor has cooled down,
then press the Reset button and restart
the unit
Tightly screw in the housing interlock
Use the pusher or add dry twigs/
branches
See section „Removing blockages"
Remove shredding material from
discharge duct
Check and turn, sharpen or replace
blades as necessary (see section
„Sharpening, turning, replacing the
blades")