Subscribe to Our Youtube Channel
Related Manuals for HiWeigh NT
Summary of Contents for HiWeigh NT
- Page 3 Warning! The form is handshaking is flag control or x-ON/X-OFF The power supply of NT-T16S printer is only DC 5V/2-3A. protocol. The parity check can be selected as Even, Odd or Never use AC mains! None by setting an internal dip switch. The signal level is 1.
- Page 4 Then push the plate back on the printer as before. (See Section 2.2 Step 4). 2.4 Power Supply The NT-T16S printer uses a 5V/2-3A DC power supply. A power supply is specially made for this series and is recommended. Insert the output plug of the power supply into the jack (Φ2.5mm) on the back of the printer.
- Page 5 plate in the side of the jack is negative. Signal level is compatible with EIA standard. Caution: Never connect AC mains directly! The baud rate of serial Interface can be selected as 150, 300, 3. Operation 600, 1200, 2400, 4800, 9600 or 19200bps. To set the baud 3.1 Serial Interface Connection rate, take off the re-movable cover and the upper case of the The 25 pin connector at the back of the VMP-T series printer...
- Page 6 3.5 Command Set Selection <1>. Self-Test Mode There is one command set in NT-T16S: ESC control codes, There are two ways to enter the self-test mode. other setting –ESC control codes ex-factory. (1) Press SEL button when power on the printer. After few seconds then release, The SEL indicator then turns off and 4.
Need help?
Do you have a question about the NT and is the answer not in the manual?
Questions and answers