Chassis Control (Netfn:00H, Cmd:02H); Ipmi Standard Command Table - Fujitsu PRIMEHPC FX700 User Manual

Chapter 4 Command Support (IPMI)
4.1 Command Tables
4.1.2

Chassis Control (NetFN:00h, CMD:02h)

Use the command to power on/off nodes.
This command only issues power-on/off instructions, and the power-on/off processing is executed separately.
If the destination is the chassis, "Not supported" (Completion Code: C1h) is the response.
Byte
Request Data 1
Response Data 1
4.1.3

IPMI Standard Command Table

This section shows a list of IPMI standard commands.
Command
Get Chassis Status Synchronous
Chassis Control Asynchronous
*1 Target for the issued command
How to Specify the Target
You can specify the target with the -t option in the ipmi command.
-t <target>
Options you can specify for the target
- 0x20 Chassis
- 0x30 Node#0
- 0x32 Node#1
- 0x34 Node#2
- 0x36 Node#3
- 0x38 Node#4
- 0x3a Node#5
Table 4.2 Chassis Control Format
[7:4] reserved
[3:0] chassis control
0h = Power down
1h = Power up
2h = Power cycle (Not supported)
3h = Hard reset
4h = Pulse Diagnostic Interrupt
5h = Initiate a soft-shutdown
6h-Fh = reserved
Completion Code
Table 4.3 Chassis Device Commands
Synchronization CMD
01h
02h
Data Field
Privilege
User Supported
User Supported
56
Target(*1)
Chassis Node
Supported
Supported
C120-0091-03EN