Electrical connection
Anti‐buckling socket,
internal Ø 7 mm
Anti‐buckling
socket, internal
Ø 5 mm
14
5.1.1
Mechanical connection of the connector
cables
The junction box includes a set of cable sleeves,
intended for bushing the transducer connection cable, the
voltage supply and the Md/n outputs. The side hole for
the external control signal is closed with a screw for
delivery. If need be, use a suitable PG7 screwed joint
with an anti‐buckling socket.
T20WN, T21WN, T22
Power
Cable sleeve
Fig. 5.3
A2335-2.0 HBM: public
Clamping ring
Rubber seal
Cable bushing "T20WN, T21WN, T22" and
"POWER" at the junction box
Cable shield
looped round
clamping ring
Wall of the housing
VK20A
Need help?
Do you have a question about the VK20A and is the answer not in the manual?