Introduction The device is intended to measure alcohol in the human breath. Measurements obtained by this device are used in the diagnosis of alcohol intoxication. The accuracy of this device has been established at a Blood Alcohol Concentration of 0.008 (0.08‰) and 0.032%(0.32‰) BAC.
Power Supply • Slide back the battery cover on the back of the device. • Insert 1 piece 9V battery, making sure that the “+/-“symbols are correctly. • If the power is too low, the unit may display a battery symbol “ “and the device may not use correctly.
Page 5
• The BLOW displays on the screen, and displays “C” with flashing. Take a deep breath, blowing steady into the mouthpiece until beeping stops (about 6 seconds). • The device displays “WAIT” and flashing the “0” on the screen. • Your test result will be displayed on the screen for 20 seconds. •...
your last 5 tested records. • The device will be turn off after displaying 20 seconds. • The memory button is only used at this mode. Accessories • Mouthpieces • Manual Errors or Troubles Error message Description Remarks or Troubles -Press and hold the TEST button until power on.
-The blood alcohol content above the display range. -Display range: 0.200%BAC Important notes • Before testing, wait at least 15 minutes after your last drinking. • The blowing time must be enough until beeping stops. • It may show ERR (error) if none, interrupt or shorter blowing. •...
Calibration Record Date First Used Serial Number Calibration Date Remarks Recalibration by Precautions • Your blood alcohol content (BAC) may change some minutes later. • You should have your alcohol tester calibrated every 12 months. Failure to do so may cause your readings to be inaccurate.
The completed RMA form and description of the problem. b. Your name, return address (Not PO Box) c. Your phone number. d. A copy of your sales receipt or invoice. trendmedic Eric Schäfer Beethovenstr. 5 D-85622 Feldkirchen Germany Telefon: +49(0)160 - 947 52 654 Fax: +49(0)89 - 99 176 780 Email: info@trendmedic.de...
Need help?
Do you have a question about the TM-7500 and is the answer not in the manual?
Questions and answers