Wellspect LoFric Series Instructions

INDICATIONS FOR USE: Intermittent catheterization of the urethra.
LoFric catheters are single-use hydrophilic urinary catheters. Once used, the unique surface coating will deteriorate and the catheter will no
®
longer be sterile. The hydrophilic coating on the catheter consists of PVP (polyvinylpyrrolidone) and sodium chloride, which reduce urethral
friction. They are used to empty the bladder of urine, occasionally and intermittently, at home or in a hospital. Not made with natural rubber latex.
NOTE: Do not place LoFric on paper or cloth, as these materials can absorb the catheter's liquid coating. Be sure to follow your healthcare provider's
instructions when using these products.
Wash your hands with soap and water before preparing the catheter as instructed below.
LoFric Primo
® ™
1. Unfold LoFric Primo.
2. Hold catheter with the picture facing away from you. Fold the sachet
forward on the blue-white border.
3. Apply pressure to both sides and press to release the water down
onto the catheter.
4. Let the catheter soak for at least 30 seconds.
5. Carefully peel open the top until you reach the funnel end of the
catheter.
6. Remove the catheter and use.
LoFric Hydro-Kit
® ™
1. Hold the bag upright, then fold and squeeze the water sachet.
2. Let the catheter soak for at least 30 seconds.
3. Invert the bag.
4. Tear off where shown, at piece "A".
5. Tear and separate "B" from "C", but don't remove it. Use "B" as
your handling aid and pull the catheter down to make a tight seal
at the bottom of "C" (around the neck).
6. After catheterizing, separate and discard the catheter by tearing at
"C". Tie a knot to seal the bag, or use our LoFric clip. Discard the
bag with its contents or tear at slit (as shown) to empty before disposal.
LoFric / LoFric Plus
®
1. Open the pack carefully. Pull the tabs open about 2 inches. Pour water
directly into the pack. Use sterile water only as directed by your
healthcare provider.
2. Remove the blue tab on the back and attach the packaging to a sink or
other convenient, dry surface.
3. Let the catheter soak for 30 seconds. The catheter is then ready to
be used.
LoFric Origo / LoFric
® ™
1. Squeeze package and break water packet to soak the catheter
before use.
2. Peel open the label and remove the catheter.
3. After use, return catheter to package and reseal label. The outer
packaging doubles as a hygenic and discreet disposal pouch.
/ LoFric Dila-Cath
®
Sense
® ™
Instructions for Preparing the
LoFric Catheter for Use
1
4
1
4
®
1
1
2 3
5 6
2 3
5 6
2 3
2 3