Table of Contents
Advertisement
2. Press a 1" Square Inner Cap (65) into the Front
Upright (42).
Slide the Front Upright (42) onto the 5/16" x
2 1/2" Carriage Bolts (1) in the Base (4). Hand
tighten two 5/16" Nylon Locknuts (3) onto the
Carriage Bolts. Do not tighten the Locknuts
yet.
3. Attach the two Weight Guides (62) inside of the
Stabilizer (5) with two 5/16" x 2 3/4" Bolts (11),
two 5/16" Washers (8), two 1/2" x 17/32" Spacers
(61), and two 5/16" Nylon Locknuts (3).
Tighten the 5/16" Nylon Locknuts (3) used in
step 1.
Slide two Weight Bumpers (19) onto Weight
Guides (62). Stack the six Weights (25) on the
Weight Bumpers (19). Make sure that all of the
Weights are turned so the large pin grooves
are on the bottom of the Weights and on the
same side of the weight stack.
Press the Weight Tube Bumper (64) into the end
of the Weight Tube (63). Insert the Weight Tube
into the stack of Weights (25). Make sure that
the pins on the Weight Tube are resting in the
pin grooves in the upper Weight.
Lubricate the insides of the holes in the Top
Weight (76). Slide the Top Weight onto the
Weight Guides (62).
2
65
3
4
3
Lubricate
Pin
Pin
Groove
Pin
Groove
19
6
42
1
62
76
63
64
25
11
8
8
61
5
3
Hide quick links:
Advertisement
Table of Contents
