Loading The Fasteners; Changing The Driver Bit - Camo EDGE PRO Owner's Manual

LOADING THE FASTENERS

FOR USE WITH CAMO
1.
2.
3.

CHANGING THE DRIVER BIT

1.
2.
COLLATED HIDDEN FASTENERS ONLY.
®
Take one 50ct strip of CAMO Collated
Hidden Fasteners and insert strip-side
down into the Feeder Rail.
Pull the strip through the Feeder Rail
and insert into the Feed Indexer. Push
until the first screw is in the drive
position. Pull the strip back carefully
to eliminate any slack.
The Depth of Drive is factory-set to a
recommended setting as shown. No
depth adjustment is necessary based
on the length of the screw.
Loosen the wing nut on the Screw Feed
Assembly and remove the Attachment.
Compress the spring-loaded Extension
Pole to expose the
Connection Collar. Compress the
spring-loaded collar to remove and
replace the Driver Bit.
collar to secure the Bit.
4. Plug the Driver Drill into a 120v outlet.
5. Ensure that the Drill is set to Forward.
6. The Tool is now ready for use.
TO UNLOAD THE FASTENERS:
Open the Screw Guide Cover and pull
1.
the strip through as shown.
3. Reconnect the Attachment to the
Driver Drill and tighten the wing nut.
Bit Holder
Release the
4