Advertisement
• Place the Small Parts Bin [G] on top of the Parts Tray [F] as
needed (FIG 7).
• Check that the Drain Plug (located at the right underside of the
Tub Floor) is tight with an 18mm wrench (not included).
• Make sure the Nozzle of the Flexible Metal "Gooseneck" Fluid
Outlet Tube is facing in toward the center of the Tub
and downward.
• Fill unit with a suitable, good quality water-based degreasing
solution sufficiently to cover the entire Inlet Filter (approx.
24 gallons).
Follow degreasing solution mixing, usage and
safety label instructions carefully before using.
• Plug power cord into an approved, grounded and GFI equipped
120 Volt AC, 60hz. Outlet.
• Turn Power Switch to the "On" position. The Parts Washer is
now ready for use.
OPERATION
• Place parts to be cleaned on the Parts Tray. Small parts may be placed in the Small Parts Bin.
• Bend "Gooseneck" so that cleaning solution to flows completely over the part surface, wetting it completely. Allow time for solution to soften any grease
and debris then use a suitable parts cleaning brush (not included) to remove stubborn deposits.
• Allow excess solution to drain from parts then remove from washer and rinse in warm water.
• When done, turn pump to the off position, close lid and unplug unit.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 7
7
Advertisement
